LED Strip Connectors for Waterproof RGB 5050 Lights - Good Connection

Installation Guide for Strip to Strip and Strip to Wire Connectors

To install the strip to strip connector, follow these steps:

Step 1: Begin by peeling off the glue from the back of the strip light. Then, open the transparent cover up to 90 degrees.

Step 2: Insert the strip into the end of the connector, making sure to keep the silicone face up. There is no need to remove the silicone glue.

Step 3: Close the cap with pliers or other tools until it is fully seated on both sides of the base.

For installing the strip to wire connector, follow these steps:

Step 1: Insert the wire directly into the guide slot without stripping. Ensure that the positive wire is aligned correctly.

Step 2: Close the cap cover with pliers. Please note that pliers are not included in the package.

Step 3: Your installation is now complete.

Product Details for 10mm Waterproof RGB Light Strips and 22-20 AWG without Stripping Wires:

• Strip to Strip Connector Width: 0.55in, Length: 0.75in
• Strip to Wire Connector Width: 0.55in, Length: 0.94in, Height: 0.24in
• Maximum Current: 5A
• Working Temperature: -20~50℃
• Cover Heat Resistance: 105℃
• Workable Strip Light Width: 10mm
• Package includes: 5× Strip to Strip Connectors, 5× Strip to Wire Connectors

Please Note:

1. Ensure that the pins pierce 4 copper pads on the FPCB when pressing down the connector with pliers quickly.
2. Quickly press on each side of the connector with pliers to allow the wire-end blade to contact the conductor.
3. Remember to turn off the power before cutting and reattaching light strips to avoid electric shock and burn.

For more information on LED strip lights and connectors, check out our range of products. Thank you for choosing SUPERNIGHT for all your lighting needs.

product information: